Go Back   Two Wheel Fix > General > Cage Hell > Cage Tech

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 03-05-2011, 05:50 PM   #1
Triple
uncomfortably numb
 
Triple's Avatar
 
Join Date: Nov 2008
Location: JOH-JAH!
Moto: WR250R & Bonneville
Posts: 409
Default Let's brainstorm.

I need to remove the old timing belt cog from the nose of my Miata's crankshaft. After much soaking in much penetrating fluid, I have tried:

- Pry bars. The cog doesn't budge; rather, the lip around the inner edge of the cog breaks off.

- A puller. There isn't enough space between the block and the cog to fit the fingers of any puller I've ever seen.

- Drilling. The hardened metal laughed at my feeble Craftsman and broke the drill bit about 1/8" in. Then I discovered there was already a hole beside the one I was drilling. I tried hammering a nail (couldn't find my punch) into the hole, hoping the pressure would split the cog. Instead, I just made the nail impossible to remove.

- Cutting. Destroyed my Dremel trying to cut through the cog with the same wheels that have easily cut through chains in the past. Managed to dig a small trench with my reciprocating saw. I hammered a chisel into the cut in hopes of splitting the cog. No luck.

- Heat. I wanted to avoid this, but I eventually tried heating it with a propane torch. No movement. I let it cool and tried heating just the nail, hoping its expansion would split the cog. No dice.

I'm out of ideas. I can't put the car back together unless I replace this stupid fucking cog.





The healthy, patiently-waiting replacement:

Triple is offline   Reply With Quote
 

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 01:52 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.