Maintenance and Riding Blog

No Worries · 04-01-2008, 12:22 PM

Last August I blew up the engine on my CBR. I've been riding my 1979 GS1000 ever since. This blog will show some maintenance tips on maintaining an older bike, and how I'll fix the engine on the CBR. The CBR engine is already apart. My wife says I can't get another bike until I put it back together. It's amazing how much area bike parts can cover when they are taken off.

I want to have one bike always ready for riding. The first thing I'll do to the Suzuki is replace the rear brake pads. The first thing I'll do to the Honda is lap and install new valves. I'll try and take good pictures and explain things.

No Worries · 05-18-2008, 06:15 PM

The needle on my tachometer was bouncing around, so I figured the cable needed greasing. I know, how quaint that my Suzuki uses cables to run the tach and speedo. The tach is run by a cable from the exhaust camshaft. I pulled that out and greased it. The speedo and odometer are run by a cable off some gears on the front axle (shown). The cable is shown pulled out of the housing.

I like using BG products for grease. I use the Special HCF grease for cables on the bike and for packing the bearings on my bicycles: http://www.bgprod.com/products/greases.html.

04-01-2008, 12:22 PM	#1
No Worries Keyboard Racer Join Date: Feb 2008 Location: Mile High City Moto: Old Superbikes Posts: 1,016	Maintenance and Riding Blog Last August I blew up the engine on my CBR. I've been riding my 1979 GS1000 ever since. This blog will show some maintenance tips on maintaining an older bike, and how I'll fix the engine on the CBR. The CBR engine is already apart. My wife says I can't get another bike until I put it back together. It's amazing how much area bike parts can cover when they are taken off. I want to have one bike always ready for riding. The first thing I'll do to the Suzuki is replace the rear brake pads. The first thing I'll do to the Honda is lap and install new valves. I'll try and take good pictures and explain things.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

05-18-2008, 06:15 PM	#2
No Worries Keyboard Racer Join Date: Feb 2008 Location: Mile High City Moto: Old Superbikes Posts: 1,016	The needle on my tachometer was bouncing around, so I figured the cable needed greasing. I know, how quaint that my Suzuki uses cables to run the tach and speedo. The tach is run by a cable from the exhaust camshaft. I pulled that out and greased it. The speedo and odometer are run by a cable off some gears on the front axle (shown). The cable is shown pulled out of the housing. I like using BG products for grease. I use the Special HCF grease for cables on the bike and for packing the bearings on my bicycles: http://www.bgprod.com/products/greases.html.