Coolest workbench

derf · 01-16-2011, 08:01 PM

I actually got a little farther than this, in fact other than putting a wooden face on the vice, and bolting the top down it's done. It weighs about 200 lbs but with the four wheel casters it rolls pretty easily. I'll wheel it out tommorrow and take some better pictures. I'm still deciding if I want to raise it another few inches, it's just bellow hip height.

Here it is while I was gluing the tail vice on the front.

The whole table

The front vice

The tail vice. The block on the left can pull right out and move over and drop into any one of the other holes along the front of the table.

01-16-2011, 08:01 PM	#1
derf token jewboy Join Date: Nov 2008 Moto: CBR 900, KLR ugly ass duckling, Gas Man Posts: 10,799	I actually got a little farther than this, in fact other than putting a wooden face on the vice, and bolting the top down it's done. It weighs about 200 lbs but with the four wheel casters it rolls pretty easily. I'll wheel it out tommorrow and take some better pictures. I'm still deciding if I want to raise it another few inches, it's just bellow hip height. Here it is while I was gluing the tail vice on the front. The whole table The front vice The tail vice. The block on the left can pull right out and move over and drop into any one of the other holes along the front of the table. __________________